Electronics

This is a 2.5-watt Artec amp circuit board with on-board on/off/volume potentiometer, pre-wired connection leads including a 9-volt battery connector. We also include a basic sheet with wiring diagrams for this board. These make great little amps, which...

If you have been wanting to try putting a piezo in your builds, but haven't been sure where to start, this is the kit for you! This is a kit of the parts and components you need to add an electric piezo pickup to your cigar box guitar. This is a perfect...

This is a flat face pre-amp unit, perfect for mounting directly into the side of your standard acoustic guitar or cigar box guitar. For standard acoustic guitars, this pre-amp gives you an on-board equalizer and volume control and helps boost and clarify...

Well folks, if you've been looking at the absolute cheapest way to avoid soldering up your own pickup wiring circuits, here you go. These are the absolute rock-bottom economy-priced wiring harnesses you'll ever hope to find. They are made overseas (of...

These external-mount 9-volt battery trays are perfect for custom amplifiers, cigar box guitars with pre-amps or active circuits, and other electronics usage! Trays such as this make it possible to change batteries without opening up the enclosure, which...

THE PSYCHO KNOB KIT: It's like injecting four different boost/distortion pedals inside your guitar or amp!   FOR GUITAR:  This simple knob requires only simple soldering to place between your volume/tone knobs and the guitar jack...

 A C. B. Gitty Crafter Supply Exclusive: the "Cap-o-Tone" pre-wired disk piezo harness for cigar box guitars and more! Includes a 2-page how-to-install guide written by C. B. Gitty himself, to help guide you through getting this great...

This is twelve (12) feet total of 24-gauge stranded copper hookup wire, perfect for wiring up your cigar box guitar, standard guitar or other electronics project! This pack contains six (6) feet each of red and black stranded copper 24-gauge wire (.060").

 A C. B. Gitty Crafter Supply Exclusive: the "Disc-o-Tone" pre-wired disk piezo harness for cigar box guitars and more! Includes a 2-page how-to-install guide written by C. B. Gitty himself, to help guide you through getting this...

These are 1/4" standard mono phone output jacks. They have a shorter shaft than the Neutriks we sell, but they are a good bit cheaper and are great for CBGs, amps and other homemade instruments. The shafts on these...

No soldering required, just plug and play! Compact size and minimal mounting plate curvature is ideal for cigar box guitars. This is a compact little powered pre-amp unit, perfect for mounting directly into the side of your ukulele or cigar box guitar...

These premoum 1/4" Neutrik (Rean) brand mono phone jacks have with a 9.5mm-long threaded shaft and "fastontab"-style solder lugs. These jacks are perfect for all sorts of electric guitars, cigar box guitars, and general audio usage. They are...